Nothing beats the feeling of indulging in a long, warm bath after a stressful day. Completed with a good book, a glass of your favorite champagne, and your go-to essential oils, this is the perfect way to relax your senses, rejuvenate your skin, and enjoy that peace you’ve been longing for. 

If your bathtub looks worn out, it might seem unappealing to relax and enjoy while bathing. The good news is that you can easily breathe new life into your old tub with expert reglazing.  

The best part about bathtub reglazing services is that you can enjoy a brand new-looking tub at a fraction of the cost of remodeling, renovation, or replacement. However, issues can still arise if they use incorrect techniques and low-quality materials. 

Here are some of the most common bathtub reglazing problems you should look out for and avoid:
1. Bubbling

Bubbling can occur when air gets trapped in between individual layers of coating. It could also happen when the coating did not cure properly, or the old finish was not stripped before resurfacing.

2. Sticky feel

A newly finished bathtub that feels sticky to the touch can happen when the coating did not cure properly. If you encounter this, do not use the tub yet as it may need to be resprayed.

3. Fading

Your reglazed bathtub can fade if the refinish coating is mixed and applied too thinly or an incorrect mixture was used. The original surface of your tub will show through eventually.

4. Peeling

Peeling can happen on your reglazed bathtub if there is a chip on its surface, which can lead to the loosening of the entire finish. This can also occur if the surface was incorrectly prepared or the glaze did not cure properly.

5. Chipping

Even though your tub has fully and properly cured, the surface of your newly reglazed bathtub can chip when your tub is subjected to a great amount of force. This commonly happens when you accidentally drop a heavy item onto the tub. To address this, you may use a blending solvent or contact your go-to professional tub refinishing company for repair.

What Are the Ways to Avoid Damaging Your Reglazed Bathtub?

To ensure the quality of workmanship and customer satisfaction, hire only the best bathtub refinishing company in your area. Make sure that before starting the project, they cover your entire bathroom and make the area well-ventilated for everyone’s safety. 

Afterward, the refinishers should completely strip away and sand down your bathtub’s old finish. They must then make a quality base for the new finish by repairing and treating each defect and imperfection on the surface of your tub, such as cracks, rust, and chips. Finally, they must prime, reglaze, and apply a sealing coat. Each coat should be given sufficient drying time to fully set and cure all materials. Once all of these steps are observed, you can enjoy your newly glazed tub up to 10-15 years.

Conclusion

Destress and enjoy a quality bath with a properly reglazed bathtub. With the assistance of a bathtub reglazing professional, you can have a bathtub that is as good as new without breaking your bank.

Make your bathtub look and feel brand new with our professional bathtub refinishing in Baltimore. Contact us at Everglaze Coatings for a free estimate!